Woodworking saw blade is also divided into carbon steel, high-speed steel and carbide and other materials, cut the root of your hard and soft wood wet and dry to choose. In the process of sawn timber which, before the opening band saw blade timber because of the impact of prolonged friction with the blade if there is no roll bending potential, it would exacerbate swings in front of the blade opening, so that the cutting blades deviation not walk a straight line, with the bend before potential blade firmness, it is a good cutting. Here are some woodworking band roll method, according to which reads:
l, the first pressure convex, flat feet with tape, according to Article checking to see if there are inherent male and female, if any, would be pressed convex surface.
2, started from the room, separated by 8 to 10 mm circles around jump pressure, the intensity is gradually reduced to a large sides, leaving 15 mm tooth belt. While the pressure gauge to check radian radians while not exceeded. Also check the trimming blade back, does not allow bending phenomenon.
3, after the completion of one side, then turn over the blade to check whether the other side there is a lack of places, if you have to continue the pressure, but it must inject idle along the platen roller, the line must not be indiscriminate. After the standard, then paragraph by paragraph examination dressing, finishing also along the platen roller. Be reversed, in line with standard front, the layering is complete.